INTEL DOES NOT WARRANT THAT THE FUNCTIONS CONTAINED IN THIS PATCH WILL MEET YOUR REQUIREMENTS, OR THAT THE OPERATION OF THIS PATCH WILL BE UNINTERRUPTED OR ERROR-FREE. //**************************************************************** qprogrammer-18.1.1-1.16p-readme.txt Readme file for Quartus Prime Programmer and SignalTap II 18.1.1 Patch 1.16p Copyright (C) Intel Corporation 2019 All right reserved. Patch created on March 06 2019 Patch Case#: 1409022777 //**************************************************************** Problem: Stratix 10 firmware is not applying optimized on-chip voltage regulator trim settings which may cause a slight timing model mis-correlation. Solution: Optimized settings, available through firmware update, will restore the correlation. Caution - You must either have previously installed the Quartus Prime Programmer and SignalTap II 18.1.1 software or must install the Quartus Prime Programmer and SignalTap II 18.1.1 software before installing this patch. Otherwise, the patch will not be installed correctly and the Quartus Prime Programmer and SignalTap II software will not run properly.