ALTERA DOES NOT WARRANT THAT THE FUNCTIONS CONTAINED IN THIS PATCH 
WILL MEET YOUR REQUIREMENTS, OR THAT THE OPERATION OF THIS PATCH 
WILL BE UNINTERRUPTED OR ERROR-FREE. 

//**************************************************************** 
quartus-10.0-1.119-readme.txt 
Readme file for Quartus II 10.0 SP1 Patch 1.119
Copyright (C) Altera Corporation 2010 All right reserved. 
Patch created on September 17 2010
Patch SPR#: 351465 
SPRs fixed: 352360
//**************************************************************** 

Problem:  The checkbox for "Use these clock settings for the DPA
	  clock" in ALTPLL megawizard has been grayed out for Arria II
	  GX device family causing customers unable to tick on the
	  checkbox , thus, PLL computation is unable to compute correct
	  value which ends up with the following Fitter Internal Error:

	  Internal Error: Sub-system: FTITAN, 
	  File: /quartus/fitter/ftitan/ftitan_expert.cpp, Line: 4418
	  Final postfit netlist check failed


Solution: This patch enables the checkbox in ALTPLL megawizard.

	  You need to regenerate your ALTPLL variation after you
	  install this patch.
	  Here are the steps:
	  1. Double click on your ALTPLL variation.
	  2. Go to page 6 of 14 and tick on the check box "Use these
  	     clock settings for the DPA clock". Click finish. This will
  	     regenerate the PLL which connects to LVDS.
	  3. Run the compilation again.


Caution - You must either have previously installed the 
          Quartus II 10.0 SP1 software or must 
          install the Quartus II 10.0 SP1 software 
          before installing this patch. Otherwise, the patch will 
          not be installed correctly and the Quartus II 
          software will not run properly.